"Factory Defaults" in DD-WRT really means "firmware defaults" because it reverts to DD-WRT's defaults. Login (password) after Reset . After a reset of DD-WRT, the firmware should ask for you to change the username and password. If it does not the reset was not successful.

Aug 12, 2016 Router Basics - DD-WRT DD-WRT has been impressing users since its inception in 2005, and is the go-to alternative router firmware due to its longevity of existence and support of the largest array of devices. Consequently, DD-WRT can claim the largest community of users. It's the backbone of what we do here at FlashRouters. DD-WRT Forum :: View topic - After flash WRT memory to v23 Oct 19, 2006

OpenWrt Project: Log into your Router Running OpenWrt

Jan 28, 2018 Recommended DD-WRT settings - The Silicon Underground Dec 24, 2015 Add a system information page to DD-WRT | TCAT Shelbyville

Enable Wi-Fi networking on your PC and associate with the device. The SSID will be set to "dd-wrt". Then browse to the DD-WRT control panel interface. If you flashed the device with firmware from dd-wrt.com, it will be on 192.168.1.1. If you flashed the device with Sputnik-default DD-WRT firmware from Sputnik's web site, it will be on 192.168

A: The default username / password combination is “root” / “admin”. Q: I did forget the password I did set, what can I do to access the router’s control panel? A: The only way to re-access your router is resetting it to factory defaults. We'll need to set that after we login. Log in with the username of root and leave the password field empty. Note: If you have installed a “tiny” build or a “snapshot” build, LuCI web interface will likely not be present and you will need to use ssh to log in as root@192.168.1.1 (telnet is no longer supported by OpenWrt-project builds) Logged in to telnet with default 'root' and 'admin' Changed password with the 'setuserpasswd [username] [password]' Entered 'reboot' Came back up and remembered the new password through telnet! Just to make sure, I logged into the web gui with the new password, selected the reboot router in the administration page. Posted: Mon Jul 05, 2010 17:44 Post subject: Default Tomato Username/Password after upgrading from DD WRT: I wanted to upgrade to Tomato firmware, the upgrade was succesfull but i forgot to do this step: Start a telnet session to your router which has DD-WRT(telnet 192.168.1.1). Then issue the command: "nvram get http_passwd" without quotes. Why? "Factory Defaults" in DD-WRT really means "firmware defaults" because it reverts to DD-WRT's defaults. Login (password) after Reset . After a reset of DD-WRT, the firmware should ask for you to change the username and password. If it does not the reset was not successful.